Prev: Not For Under 18
Next: auto-changeover propane regulator
From: GregS on 22 Jun 2010 16:18
I was wondering if there is any code preventing more than one wire out of a panel breaker.
The reason is attempting to install a surge surpressor on existing lines.

greg
From: "Malcom "Mal" Reynolds" on 22 Jun 2010 17:39
In article <hvr5p1$4ca$1(a)usenet01.srv.cis.pitt.edu>,
zekfrivo(a)zekfrivolous.com (GregS) wrote:

> I was wondering if there is any code preventing more than one wire out of a
> panel breaker.
> The reason is attempting to install a surge surpressor on existing lines.
>
> greg

If you can do it, use a whole house surge supressor that uses an existing slot.

But I would imagine two circuits out of any breaker is not to code
From: GregS on 23 Jun 2010 08:58
In article <atlas-bugged-517908.14392322062010(a)aquila.ka.weretis.net>, "Malcom \"Mal\" Reynolds" <atlas-bugged(a)invalid.invalid> wrote:
>In article <hvr5p1$4ca$1(a)usenet01.srv.cis.pitt.edu>,
> zekfrivo(a)zekfrivolous.com (GregS) wrote:
>
>> I was wondering if there is any code preventing more than one wire out of a
>> panel breaker.
>> The reason is attempting to install a surge surpressor on existing lines.
>>
>> greg
>
>If you can do it, use a whole house surge supressor that uses an existing slot.
>
>But I would imagine two circuits out of any breaker is not to code

I just found out the breaker specs seem to determine how many wires can attach
and what size. That could still violate some codes.

greg
From: John Weiss on 23 Jun 2010 12:13
GregS wrote:

> I was wondering if there is any code preventing more than one wire
> out of a panel breaker. The reason is attempting to install a surge
> surpressor on existing lines.
>
> greg

It is against code in Washington state.
 | 
Pages: 1
Prev: Not For Under 18
Next: auto-changeover propane regulator