Prev: Washing Machine Lint Trap / Drain Protector
Next: Whirlpool Refridgerator dispenser water strange taste and odour after replaceing filter
From: catherine on 5 Dec 2006 04:56

Thanks very much to Mr Jordan for posting the reset instructions here!

After I had an overflow of my Ariston LSI61 built-in dishwasher and
cleared the blocked filter, I found that the first light (overflow
error) was blinking. After some fiddling with the buttons, I could
select a wash cycle but for any cycle attempted, the machine refused to
fill with water. The motor could be heard, and it would stay in the
same state (without water) until switched off.

I couldn't get a repair engineer with my warranty out for 8 days - far
too long to be without a dishwashwer so I thought I'd try to find a fix
myself.

I found numerous postings on the web of people with similar problems
but no reply other than the link to a site where you had to pay money
and wait 14 days for reset instructions.

I followed the suggestion here, pulling my dishwasher out one inch to
access the controls whilst the door is closed (necessary for entering
the test modes), entering one of the test modes (I chose the long test)
and back to the user mode. After the first few seconds of the test, I
could hear the water running and the dishwasher filling. The test ran,
and I entered user mode again. Now the dishwasher works!

Thanks again for these excellent instructions! This saved a service
call and an 8-day wait!

Catherine




--
catherine
 | 
Pages: 1
Prev: Washing Machine Lint Trap / Drain Protector
Next: Whirlpool Refridgerator dispenser water strange taste and odour after replaceing filter